Identifies10/100 Ethernet with new Network Identification
feature
Measures cable length and distance to faults via Time
Domain Reflectometry (TDR) technology
Test twisted pair and coax cable
Matches (UTP or coaxial) cables to offices during adds,
moves and changes
Specifications
Products
Specs
MicroScanner Pro
Dimensions
5.5" x 3.25" x 1" (139.7 x 82.5 x 25.4 mm)
Battery
9-volt alkaline battery; low battery indication
Display
Custom LCD, 1.75" x .85"
Applications
Shielded (STP) and UTP cable; 75 or 50 Ohm Coaxial cable;
10 Base-T or 10/100 Base-T networks
Main tester interface
Modular 9 connector for length, 10/100 link
identification, wire map, office identifier, toner;
loopback interface:module 8 connector used for patch cable
wiremap
Length measurement
Measures length on all 4 pairs and displays in feet or
meters;max length 1500 ft (457 m)
Length calibration
User selectable NVP, NVP calculation based on known cable
length (min.length 50 ft (15 m) and max. length 1500 ft
(457 m)
Wiremap and Office/Identifier
Faults detected:Opens, Shorts, Reversed pairs, Swapped
pairs, and Split pairs, distance maximum length: 656 ft
(200/m)
Office Identifier
6 passive test plugs attached to far end (identified as
#1-3 and #5-7); distance maximum length 656 ft (200 mm)
Toner frequency
User may select 1 of 4 predefined tone sequences
Toner interface
Main Mod8 port for tone generation on all 4 pairs. Ground
jack provided for grounding MicroScanner Pro during trace
operations.
High voltage input/protection
The test interface withstands input hazard conditions that
arise from normal telephone interfaces (48 VDC at less
than 80 mA) or 24 VAC power used to power many telephone
key sets
